Water Damage Services in St. George
Water damage restoration is what we do — nothing else. That focus means we do it better than a general contractor. Here are our services.
Water Damage Restoration
Water damage restoration means getting the water out, getting the structure dry, and making sure mold doesn't take hold. Our St. George crews use truck-mounted extraction units for speed, then transition to LGR dehumidifiers and high-velocity air movers for the drying phase. We take moisture readings every day with both pin-type and pinless meters — you'll see the numbers dropping. When readings hit dry standard, we verify with a final thermal imaging sweep. The whole process runs 3-7 days depending on how much water we're dealing with.
Get a Free Quote →
Emergency Water Extraction
Professional emergency water extraction service in St. George, UT.
Get a Free Quote →
Flood Cleanup
Floods in St. George tend to happen fast — monsoon rain overwhelms drainage systems, or a retention basin overflows. When that happens, you need pumps in your property immediately. Our flood cleanup crews bring submersible pumps, truck-mounted extraction units, and enough hose to reach anywhere on your property. After extraction, we strip out flood-contaminated materials (flood water is Category 3 — it's not clean), sanitize all surfaces, and set up drying equipment. We also coordinate with St. George utilities if there's any concern about electrical safety.
Get a Free Quote →
Sewage Cleanup
Sewage backup is a Category 3 water loss — the most hazardous category. Our St. George sewage cleanup crews wear full PPE including Tyvek suits and respirators. We extract contaminated water with dedicated equipment (separate from our clean-water extractors), remove all porous materials that contacted sewage (carpet, pad, lower drywall, insulation), apply hospital-grade antimicrobial treatment to remaining surfaces, and sanitize the entire affected area. EPA disposal protocols for all contaminated materials.
Get a Free Quote →
Mold Remediation
Mold is almost guaranteed in Utah when water damage goes untreated for more than 48 hours — the heat and humidity create perfect conditions. Our mold remediation follows IICRC S520 standards: containment with negative air pressure, removal of affected materials in sealed bags, HEPA air filtration throughout, antimicrobial treatment of remaining structures, and post-remediation air testing by a third-party lab. We don't do mold testing and mold removal — that's a conflict of interest. We recommend an independent hygienist for pre-testing.
Get a Free Quote →
Storm Damage Repair
When a storm hits St. George, our phone lines light up. We triage by severity — active flooding and structural damage get priority. Emergency board-up and tarping crews go out first to stop further damage. Then our restoration teams follow up with water extraction, drying, and repairs. We've handled the aftermath of every major storm event in St. George for the past 15 years.
Get a Free Quote →
Basement Waterproofing
Professional basement waterproofing service in St. George, UT.
Get a Free Quote →
Structural Drying
We're drying nerds. Seriously. Our techs calculate the exact equipment load using psychrometric charts — how many air movers, what type of dehumidifiers, where to place them for maximum efficiency. In St. George's climate, getting the right dehumidifier type matters (LGR units perform better in our humidity range). We take daily moisture readings with pin meters, pinless meters, and thermal hygrometers, and we adjust equipment as the drying progresses. You get a detailed drying log at the end.
Get a Free Quote →
Content Restoration
Don't assume your stuff is destroyed. Our content team has saved wedding photos, antique furniture, business records, and electronics from water damage. We do careful pack-out with chain-of-custody documentation, process everything at our restoration facility, and return it cleaned and restored. Insurance covers content restoration under most homeowner policies — we handle that paperwork too.
Get a Free Quote →